Flowjet Valves : Industrial Valves Manufacutrer

FORGED STEEL CHECK VALVE

A check valve or non-return valve which normally allows to flow through it in only one direction.

Check valves are two-port valves, means they have two openings in the body, one for fluid to enter and the other for fluid to leave. There are various types of check valves used in a wide variety of applications. Although they are available in a wide range of sizes and costs, Check valves work automatically and most are not controlled An important concept in check valves is the cracking pressure which is the minimum upstream pressure at which the valve will operate.

A swing check valve or tilting disc check valve is check valve in which the disc, the movable part to block the flow, swings on a hinge or trunnion, either onto the seat to block reverse flow or off the seat to allow forward flow.

A lift-check valve is a check valve in which the disc, can be lifted up off its seat by higher pressure of inlet or upstream fluid to allow flow to the outlet or downstream side. A guide keeps motion of the disc on a vertical line, so the valve can later reseat properly. When the pressure is no longer higher, gravity or higher downstream pressure will cause the disc to lower onto its seat, shutting the valve to stop reverse flow.

SIZE RATING

Rating: 800#
15 TO 50MM Or 1/2 TO 2Inches
Rating: 1500#
15 TO 50MM Or 1/2 TO 2Inches
Rating: 2500#
15 TO 50MM Or 1/2 TO 2Inches
SIZE AND RATINGS
Size 800#15 to 50 m.m.
1500#15 to 40 m.m.
2500#15 to 25 m.m.
MANUFACTURING STANDARDS
MFG DESIGNBS 5352/API 602
Face TO Face DESIGNMFG
End connectionSsrewed End/soket Weld End/ Butt Weld end
KEY FEATURES
  • The product designs are in accordance to ANSI B16.34 / BS1868 / IBR with reliable sealing & sturdy construction to ensure excellent performance.
  • Suitable for the horizontal & vertical pipe runs.
  • “NON-SLAM” arrangement i.e. Dash Pot arrangement can be provided.
  • Pressure sealed bonnet for ANSI#900 and above to provide excellent sealing against increased line pressure.
  • Full range of Body / Cover / Bonnet & Trim material.
  • Valves are available in both Flange End & Butt Weld ends.
MATERIAL
1BODY&COVERASTM A 105/F11/F22/LF2/F304/F304L/F316/F316L/F51/F53/F55/F347/F321/INCONEL 625/MONEL 400/HASTELLOY C276/ALLOY 20
2DISCASTM A 217 Gr CA15/ASTM A 351 Gr CF8/CF8M/CF3/CF3M
3seat ringASTM A 479 TYPE SS410,SS304,SS316,SS304L,SS316L/FS A 182 F304/F316/F304L/F316L
4Gasket/304/SS316 Sairal Wound Grafite Filer
5BODY&COVER JOINT BOLTASTM A 193 Gr B5/B6/B7/B7M/B16/B8/B8A/B8C/B8M/B8MN