Flowjet Valves : Industrial Valves Manufacutrer


A check valve or non-return valve which normally allows to flow through it in only one direction.

Check valves are two-port valves, means they have two openings in the body, one for fluid to enter and the other for fluid to leave. There are various types of check valves used in a wide variety of applications. Although they are available in a wide range of sizes and costs, Check valves work automatically and most are not controlled An important concept in check valves is the cracking pressure which is the minimum upstream pressure at which the valve will operate.

A swing check valve or tilting disc check valve is check valve in which the disc, the movable part to block the flow, swings on a hinge or trunnion, either onto the seat to block reverse flow or off the seat to allow forward flow.

A lift-check valve is a check valve in which the disc, can be lifted up off its seat by higher pressure of inlet or upstream fluid to allow flow to the outlet or downstream side. A guide keeps motion of the disc on a vertical line, so the valve can later reseat properly. When the pressure is no longer higher, gravity or higher downstream pressure will cause the disc to lower onto its seat, shutting the valve to stop reverse flow.

DesignApi 6d / Api 594 / Asme b 16.34
Face to faceApi 6d / Api 594
TestingApi 6d / aAi 598
MaterialASTM specifications
TrimsSoft seat for tight shut-off.
OptionalASTM Specifications
TrimsVarieties of combinations.
Lesser weight, smaller size and lesser force to open.
OptionalReplacement of conventional check valves without pipeline modification.
  • The product designs are in accordance to ANSI B16.34 / BS1868 / IBR with reliable sealing & sturdy construction to ensure excellent performance.
  • Suitable for the horizontal & vertical pipe runs.
  • “NON-SLAM” arrangement i.e. Dash Pot arrangement can be provided.
  • Pressure sealed bonnet for ANSI#900 and above to provide excellent sealing against increased line pressure.
  • Full range of Body / Cover / Bonnet & Trim material.
  • Valves are available in both Flange End & Butt Weld ends.
1BodyA 216 gr. WcbA 217 gr. C5A 352 gr. LcbA 351 gr. Cf8m
2Seat ringWcb + 13% cr. SeelWcb + 13% cr. SeelA 352 gr. Lcb+ss304A 351 gr. Cf8m
3Soft seated ringEpdm / nitrile vition / neopreneEpdm / nitrile vition / neopreneEpdm / nitrile vition / neopreneEpdm / nitrile vition / neoprene
4DiscA 217 gr. Ca15A 217 gr. Ca15A 352gr. Lcb+ss304A 351 gr. Cf8m
5SpringSs304 / inconelSs304 / inconelSs304 / inconelSs316 / inconel
6HingeA 216 gr. Wcb/ a 217 gr. Ca15A 217 gr. C5/ a 217 gr. Ca15A 351 gr. Cf8/ a 352 gr. LcbA 351 gr. Cf8m
7Flange sealEpdm / nitrile vition / neopreneEpdm / nitrile vition / neopreneEpdm / nitrile vition / neopreneEpdm / nitrile vition / neoprene
8Stem shaft / hinge pinA 276 tp 410A 276 tp 410A 276 tp 304A 276 tp 316